Freight Toboggan - Canadian Made

Our freight toboggan is constructed from ultra high molecular weight polyethylene (UHMWPE), with hardwood (ash) crossbars attached by stainless steel screws. It is intended for hauling winter camping gear, pulled by people on snowshoes or skis (not a dog sled).

UHMW is very slippery, so provides very little resistance when pulled over the snow. For this reason, it is not to be used for downhill recreation. UHMW is not prone to shattering in very cold temperatures like some other plastics. Since it remains flexible, it bends to the contours of the terrain making it stable on relatively level ground. Edges are left "sharp" to accommodate turns and inclines. It is recommended that gear be lashed to the side running lines (either with or without a “tank” –canvas or tarp covering for snowproofing).

The pull lines are attached relatively low at the front to provide efficient forward pull, with a little upward tension to ride over soft or deep snow. The pull harness uses rope and wider nylon seat-belt webbing, and the length of pull line is adjustable to suit personal preference, weather and terrain conditions. Position the harness where most comfortable; over either shoulder, across the chest or around the waist.

For downhill travel or crossing a slope a second person may be needed to “back rope” to impede free downhill run (or into the haulers legs), or to prevent the loaded toboggan from sliding sideways or rolling.

The toboggan rolls up for transporting in car trunks and travel via plane and train.

Recommended reading; "A Snow Walker's Companion”.

Specs:
Width: 38 cm (15")
Length: 3m (10ft) or 2.45M (8ft)
UHMWPE thickness: 0.64cm (1/4")

Crossbars set 61cm (2ft) apart, are 3.8cm (1.5") wide Canadian ash.

MADE IN CANADA